Zepcam T2(+) does not respond in the Docking Station

Follow

If the Zepcam T2(+) behaves oddly, or does not respond to button presses:

  1. Reset the T2(+) by pressing the button on the back of the camera.
  2. Make sure the Zepcam T2(+) is not recording when docked.
  3. On the docking station, when the LED in front of the camera is Flashing Green/Red, an Error occurred and user interaction is needed. Remove the T2(+) from the docking station and place it again firmly in docking station (make sure the tilt stud is in the correct position when docked).
  4. If 1, 2 and 3 are not the solution, try a different position on the docking station.
Was this article helpful?
0 out of 0 found this helpful

Comments

Powered by Zendesk